Tweet
Selling the plasma cutter I bought from Richard - I don't really need it as much as I need a welder, so I'm selling this to buy a welder. I've got it listed on Craigslist for 700 (paid 800 for it and used it twice to destroy a fan).
Here are a few links for comparison shopping: http://www.shopperschoice.com/item_n...source=froogle
Here is the description:
Firepower Plasma Cutting System 12 Amp 115V With Built-In Compressor: The FP18 is a 110V 1/8 inch capactity plasma cutting system with an on board air compressor. Simply plug the unit into a 110 volt outlet and the system will 10 cut gauge, 1/8 inch mild steel at 9 IPM. No more air compressor to haul around. The internal compressor insures clean, dry air with no need for a filter. Features: Operates on standard 115 volt current Built-in air compressor - Portable & Self Contained! Cuts mild steel, stainless steel, aluminum, copper or brass Weighs only 55 lbs! Features a pilot-arc that burns through paint and rust Drag tip system allows placement in tight spaces and awkward locations Substantially reduces joint prep time - Warping does not occur and slag removal is not required. Long consumable life/low cost per cut Firepower automatic torch restart system Comes complete with: 20 ft. Genuine Firepower drag torch system, 6 ft. Power cord with plug, Specifications: Input voltage - 115V 60HZ Input current - 20 Amps Maximum output - 18 Amps Rated output - 12 Amps Rated duty cycle - 30 Maximum cutting capacity - 1/8 inch Cutting speed (mild steel) - 20ga. /60 inch Per Minute, 18ga. /60 inch PM, 10ga. /12 inch PM, 1/8 inch/9 inch PM Weight - 55 lbs.
Here are a few links for comparison shopping: http://www.shopperschoice.com/item_n...source=froogle
Here is the description:
Firepower Plasma Cutting System 12 Amp 115V With Built-In Compressor: The FP18 is a 110V 1/8 inch capactity plasma cutting system with an on board air compressor. Simply plug the unit into a 110 volt outlet and the system will 10 cut gauge, 1/8 inch mild steel at 9 IPM. No more air compressor to haul around. The internal compressor insures clean, dry air with no need for a filter. Features: Operates on standard 115 volt current Built-in air compressor - Portable & Self Contained! Cuts mild steel, stainless steel, aluminum, copper or brass Weighs only 55 lbs! Features a pilot-arc that burns through paint and rust Drag tip system allows placement in tight spaces and awkward locations Substantially reduces joint prep time - Warping does not occur and slag removal is not required. Long consumable life/low cost per cut Firepower automatic torch restart system Comes complete with: 20 ft. Genuine Firepower drag torch system, 6 ft. Power cord with plug, Specifications: Input voltage - 115V 60HZ Input current - 20 Amps Maximum output - 18 Amps Rated output - 12 Amps Rated duty cycle - 30 Maximum cutting capacity - 1/8 inch Cutting speed (mild steel) - 20ga. /60 inch Per Minute, 18ga. /60 inch PM, 10ga. /12 inch PM, 1/8 inch/9 inch PM Weight - 55 lbs.
Comment