Building A lowrider hearse, some questions

[Dropped84]

More things falling into place, was able to use 4 of the casket handle screws to mount my solenoids and 2 on the side to mount my wiring block. so less holes Im happy.
Hearse project 2010 142.jpg

Hearse project 2010 145.jpg

Hearse project 2010 150.jpg

[Creepy Cruiser]

Looks like it's coming out very nice.

[Dropped84]

Thanks, I would be getting more done but its gone from 70's-80's to 30's-20's and snow here afew times lately... Damn Ohio. and plus Im still short afew hydro parts I gotta buy. But I did start extentending my upper a-arms... Of coarse not finished yet Im lazy. lol
Hearse project 2010 157.jpg

Hearse project 2010 164.jpg

Hearse project 2010 173.jpg

[Dropped84]

Damn I gotta get this thing lower.... Still have the bump stops in and all not 100% bolted in...

Hearse project 2010 183.jpg

Hearse project 2010 184.jpg

[Dropped84]

Well this set of rollers kinda gets in the way of my cylinder holes, So I tried to do my best and not hack them up and I still need them in that area to help hold some weight so I didnt want to leave them out. So I desided to pick out the worst set of rollers and switch em (if they need cut) and If I turn these 2 around the opposite way its much better, didnt even have to cut one side and just a corner on the other, so this way when spun back around down the road they will still look ok.....

Hearse project 2010 198.jpg

Hearse project 2010 197.jpg

Hearse project 2010 199.jpg