I am doing the engine swap in my '62 Superior Caddy.
The only thing still attached is the driveshaft. The u-joint is press-fit in both the trans yoke and the driveshaft (which runs thru the center frame rail)
When I pull the engine and tranny together, removing the yoke, am I going to empty the tranny fluid onto the floor as it tips up and out?
The only thing still attached is the driveshaft. The u-joint is press-fit in both the trans yoke and the driveshaft (which runs thru the center frame rail)
When I pull the engine and tranny together, removing the yoke, am I going to empty the tranny fluid onto the floor as it tips up and out?
Comment