Sorry I totally missed (or just forgot about) the little blurb about some being pressed in. For the skid bars (runners) I guess that wouldn't be a problem...we'd just need to drill holes so it would be a nice tight/snug fit. The pin plates (bier tracks) we'd ideally like to screw in (just to be safe)...since it isn't in a car where you have more variables holding the casket there compared to an all open hearse.
While I am still looking (and talking with a few people) for items for my initial request...I have a slightly new one.
I need 2 runners from an Eureka set (pictured below)
DSCN1546.jpg
Also I'm wondering if anybody has the bier pins setup for a urn (see below)
Urn_carrier.jpg
We could make a stationary one...but it'd be nice if we could find an adjustable one with a 1/2" pin. I also may need a couple regular bier pins in the near future (depending on if I purchase any of the sets I'm looking at right now).
Let me know guys!
While I am still looking (and talking with a few people) for items for my initial request...I have a slightly new one.
I need 2 runners from an Eureka set (pictured below)
DSCN1546.jpg
Also I'm wondering if anybody has the bier pins setup for a urn (see below)
Urn_carrier.jpg
We could make a stationary one...but it'd be nice if we could find an adjustable one with a 1/2" pin. I also may need a couple regular bier pins in the near future (depending on if I purchase any of the sets I'm looking at right now).
Let me know guys!
Comment